Benelli TNT125 Service Manual

Wheel/Tire
Checking Tire Pressure
●Remove the valve cap.
●Measure the tire pressure with an air pressure gauge
[A] when the tire is cooled .
●Reinstall the valve cap back.
★If necessary, adjust the tire pressure according to the
relevant specifications.
Pressure (when the tire is cooled)
Front wheel: 190±10 kPa
Rear wheel: 210±10 kPa
Checking Whether Wheel/Tire is Broken
●Clear the stones [A] or other foreign matters
embedded on the thread.
●Visually check whether there are crack [B], notch [C]
and nail [D] on the tire and replace the tire if necessary.
If the tire expands or protrudes, the inside is damaged
and the tire needs to be replaced.
●Visually check whether there are crack, notc
h and
dent on the wheel.
★If any damage is found, replace the wheel according
to the situations.
- 65 -

Benelli TNT125 Specifications

General

Displacement	125 cc
Transmission	5-speed
Fuel System	EFI
Fuel Capacity	7.2 liters
Seat Height	780 mm
Dry Weight	116 kg
Bore x Stroke	54 mm x 54.5 mm
Starting System	Electric
Wheelbase	1215 mm
Engine Type	Single cylinder, 4-stroke, air-cooled
Front Suspension	Upside-down fork
Front Brake	Single disc
Rear Brake	Single disc
Front Tire	120/70-12
Rear Tire	130/70-12
Max Power	8.2 kW (11.1 Cv) @ 9500 rpm
Rear Suspension	Swing arm with lateral shock absorber with adjustable spring preload