Benelli TNT125 Service Manual

Starter Relay
Disassembling Starter Relay
●Disconnect the
starter motor cable and battery
negative electrode (-
) cable disconnection connector
[A] from the starter relay
●Disconnect the starter motor cable and battery
positive electrode (+) cable disconnection connector
[B] from the starter relay
●Unplug the starter relay cable connector
● Take out starter relay
Checking Starter Relay
●Check
Remove the body protector.
When the main switch is rerated to “ON”, check
whether a “click” sound is made after turning on starter
motor.
It is normal when a sound is made.
When there is no sound:
• Check starter relay voltage.
• Check bond strap circuit of starter relay.
• Check the operation of starter relay.
●Ch
eck voltage of starter relay
Erect main foot, and measure the voltage between the
negative electrode
(green/yellow) of starter relay
connector and bond strap of motorcycle body.
Place the main switch at the position of “ON”, pull the
brake lever and ensure that the battery voltage meets
the regulations.
When no voltage is applied to the starter relay wire,
check the continuity and wire of brake switch.
Black
Green /
yellow
Bond strap
Starter relay
- 448 -

Benelli TNT125 Specifications

General

Displacement	125 cc
Transmission	5-speed
Fuel System	EFI
Fuel Capacity	7.2 liters
Seat Height	780 mm
Dry Weight	116 kg
Bore x Stroke	54 mm x 54.5 mm
Starting System	Electric
Wheelbase	1215 mm
Engine Type	Single cylinder, 4-stroke, air-cooled
Front Suspension	Upside-down fork
Front Brake	Single disc
Rear Brake	Single disc
Front Tire	120/70-12
Rear Tire	130/70-12
Max Power	8.2 kW (11.1 Cv) @ 9500 rpm
Rear Suspension	Swing arm with lateral shock absorber with adjustable spring preload