Benelli TNT125 - Page 243

(7N•m).
●Clean the assembling surface and other joint surfaces.
●Apply sealant at the assembling surface:
Note:
Apply sealant around the bolt hole evenly, and
prevent sealant going i
nto the lubricating oil
passage of crankcase.
●
After the internal parts of left crankcase are
assembled, assemble the right crankcase to left
crankcase, and slightly knock the crankcase with a soft
hammer;
●Bolts for assembling crankcase
Note:
Tighten the assembling bolt on the left
crankcase, the tightening torque of which should
meet the requirements (10N•m);
Then tighten the assembling bolt on the
right crankcase, the tightening torque of which
should meet the requirements (10N•m);
- 240 -