The Control List
Manpack Transceiver 2110 series Reference Manual 233
Cfg Incoming Msg Set whether or not the transceiver displays a message to the
operator when it is received.
If you want to:
• display messages and log them in the Calls In Log, select
Show and log
• prevent messages from being displayed, but still log them in
the Calls In Log, select Just log
Show and log
Cfg LBT Data
Sensitivity
Set the level of sensitivity to reduce false or weak detection of data
signals when LBT is active.
You may set the sensitivity level between –0.5 to +0.5 in steps of
0.002.
0
Cfg LBT Mode Set whether or not the transceiver listens for calls and traffic on a
channel before initiating a call.
If you want to:
• use LBT for every call, select Enabled
• use LBT, with the option to override for every call, select
Override allowed
• disable LBT for all calls, select Disabled
For more information on listening before transmitting see
page 202, Listen Before Transmit Mode.
Override
allowed
Cfg LBT Period Set the length of time that the transceiver listens for calls and
traffic on a channel before initiating a call.
2 seconds
Cfg LBT Waveforms Set the waveform that LBT monitors.
If you want to monitor:
• voice calls made using a Voice Only call system, or any call to
another station made using a Codan Selcall or ALE/CALM
call system, select Voice and calls
• voice calls made using a Voice Only call system, any call to
another station made using a Codan Selcall or ALE/CALM
call system, or any calls made via a data modem, select
Voice, calls and data
Voice and
calls
Cfg Low Current
Mode
Set the level of current used by the transceiver during muted
operation.
If you want to:
• extend the time remaining for your battery, select Auto
• reduce the time remaining for your battery and improve the
receiver’s performance in areas of high off-channel signal
levels, select Disabled
Auto
Table 31: Entries in the Control List (cont.)
Name of entry Use this entry to... Default
To Next Page
Loading...
