The Control List
236 Manpack Transceiver 2110 series Reference Manual
Clarifier Improve the quality of received voice by adjusting the frequency
of the currently selected channel/mode to exactly match that of the
received signal.
You can also display the Clarifier screen by pressing CLAR.
Customer Device Display the Codan type number of the device. 2110
Customer Name Display the ISO (sales order number) customer name.
Customer Profile Display the ISO customer profile.
Customer Radio Display the ISO transceiver type. 2110 or
2110v
Customer Reference Display the ISO customer reference.
Devices Do the following:
• perform a built-in test
• display the serial number
• enter option codes
• display the list of features installed and enabled in the
transceiver
• uninstall an RM50 HF Data Modem
• display the firmware version
• display the product name
• rename the transceiver
• gain access to the lists
For more information see page 251, Devices entry.
Easitalk Switch Easitalk™ on or off.
You can also toggle Easitalk™ by pressing EASITALK.
On
Free Tune Use the transceiver to tune to any frequency between 250 kHz and
30 MHz.
GPS Error Time Set the time the transceiver waits to receive updated GPS
information before it displays an error message. The GPS Error
Time entry is only active when Option GPS Enable is installed,
and the RS232 Mode entry is set to GPS.
10 minutes
NOTE
You cannot make Send Position calls until the transceiver
receives valid GPS information. If you send an
Emergency call before valid GPS information is received,
the message No GPS data available is sent with the
call. If you receive a Get Position call, the same message
is sent to the caller.
When valid GPS data is received, a message is displayed on the
front panel to inform you of this.
Table 31: Entries in the Control List (cont.)
Name of entry Use this entry to... Default
To Next Page
Loading...
