The Control List
Manpack Transceiver 2110 series Reference Manual 237
GPS Screen Display information about your GPS position. For more
information see page 259, GPS Screen entry.
Help Mode Switch Help Mode on or off. When Help Mode is switched on, the
front panel screen displays a detailed description of the screen you
are on. When Help Mode is switched off, the top line displays the
standard description for the screen.
Off
Key Beep Switch key beeps on or off.
When you press a key that is appropriate for the task you are
performing, the transceiver makes a valid beep. When you press an
inappropriate key, the transceiver makes an error beep. If key
beeps are switched off, the transceiver still beeps when it
transitions between certain modes, for example, logging out of
admin level, and entering and exiting secure mode.
On
Key Hold Time Set the length of time that a key must be held down for a hold
action.
0.5 seconds
Key Repeat Rate Set the speed with which the , , and keys repeat when
they are held down.
0.2 seconds
Key Scroll Speed Set the speed with which the characters on a key scroll when the
key is held down.
1 second
Key Timeout Set the time the transceiver waits between two presses of the same
key to display the next character on the key. When this time
elapses, the transceiver inserts the character displayed and moves
the cursor to the next space.
1 second
LQA Screen
(MIL-STD-188-141B
ALE option only)
Display information regarding the most recent LQA information
update. The information includes the remote station address, local
and remote BER/SINAD, LQA score, and best channel/mode. For
more information see page 263, LQA Screen entry.
Macro Pause Set the pause time of macros that have been set to operate Before
pause or After pause. The macro pause time is also the time
that each step in a macro is displayed when the Macro Single Step
entry is switched on. For more information on macros and hot keys
see page 337, Hot keys.
3 seconds
Macro Single Step Switch single-stepping through macros on or off. This enables you
to debug macros by running them a step at a time. For more
information on macros and hot keys see page 337, Hot keys.
Off
Manual Tune Manually tune the antenna.
You can also display the Manual Tune screen by pressing TUNE.
Messages Store up to 10 messages for use in Get Status and Message calls.
For more information see page 264, Messages entry.
Table 31: Entries in the Control List (cont.)
Name of entry Use this entry to... Default
To Next Page
Loading...
Need help?
General
