System messages
Manpack Transceiver 2110 series Reference Manual 373
Key <name of key>
is stuck
A key on the front panel is stuck down. Release the key.
Link quality
<progress of clearing action>
You have selected to clear the ALE link quality analysis information
from the transceiver and the progress of the clearing activity is
displayed.
List is full You have attempted to create an entry or add an item to a list that is
full. Delete some entries/items.
Locked entry
Locked list
Locked setting
You have attempted to edit a locked list, entry or setting. If the item
was locked at the same access level in which you are currently
logged, or at a lower level, you can unlock the item using the Unlock?
entry in the List Manager.
For example, if an entry was locked at user level and you logged in as
a user, you can unlock the entry (see page 133, Locking and unlocking
information).
Low battery Battery voltage is very low. Recharge or replace the battery. If the
transceiver is installed in a vehicle, start the vehicle to recharge the
battery.
Low battery
<period of time> remaining
The battery pack attached to the transceiver has detected that the
charge remaining in the battery is low. Replace the battery pack with
one that is fully charged, or recharge the battery pack.
Low battery
recovered
The previous low battery condition for the battery is resolved.
Low Power Only You have attempted to change the transmit power level to one that is
not permitted for the frequency selected, for example, a CB
frequency.
Macro error:
recreate macro for <name of
macro>
An error occurred when the transceiver tried to create the macro.
Create the macro again.
Macro memory
is full
The memory storage for macros is full. You must delete one or more
macros before you can create another.
Macro update needed
Delete a few unused macros
to make room for new
macros
The macros programmed through NSP are inconsistent with the
current version of transceiver unit firmware, and the transceiver has
insufficient memory space to update the macros. Delete one or two
macros then switch the transceiver off then on again.
Macros updated
Reload Keypad List in NSP
and save a new profile for
use with version <firmware
version> and higher
NSP has downloaded an old set of macros that are inconsistent with
the current version of transceiver unit firmware. Load the new
Keypad List from the transceiver into a new profile for use with this
version of transceiver unit firmware and higher.
Table 53: System messages (cont.)
Message Description
To Next Page
Loading...
Need help?
General
