Codan 2110 series User Manual

System messages
374 Manpack Transceiver 2110 series Reference Manual
Memory error:
Address List reset
The Address List has been reset to its factory-default contents due to a
memory error. If you created any entries in this list you must re-create
them, as required, or reload the profile into the transceiver using NSP.
Memory error:
all lists reset
Firmware in the transceiver has been upgraded. As the layout of data
in each list has changed from the previous version of firmware, all
lists have been reset to their factory-default contents. Re-create the
entries and/or re-enter the values in each list, as required, or reload the
profile into the transceiver using NSP.
Memory error:
Calls In Log reset
The entries in the Calls In Log have been deleted due to a memory
error.
Memory error:
Calls Out Log reset
The entries in the Calls Out Log have been deleted due to a memory
error.
Memory error:
Keypad List reset
The Keypad List has been reset to its factory-default contents due to a
memory error. If you created any macros or modified any key
assignments you must re-create and/or re-enter them, as required, or
reload the profile into the transceiver using NSP.
Memory error:
macros reset
The macro database has been reset to its factory-default contents due
to a memory error. If you created any macros you must re-create
them, as required, or reload the profile into the transceiver using NSP.
Memory error:
one or more lists reset
Firmware in the transceiver has been upgraded. As the layout of data
in some lists has changed from the previous version of firmware,
some lists have been reset to their factory-default contents. Re-create
the entries and/or re-enter the values in each list, as required, or reload
the profile into the transceiver using NSP.
Memory error:
Phone Link List reset
The Phone Link List has been reset to its factory-default contents due
to a memory error. If you created any entries in this list you must re-
create them, as required, or reload the profile into the transceiver
using NSP.
Memory error:
station addresses reset
Your station self addresses have been reset due to a memory error. Re-
enter these self addresses, as required, or reload the profile into the
transceiver using NSP.
Memory error:
write failed
An error occurred when the transceiver tried to write to non-volatile
memory. Retry the task that caused the error. If the problem persists,
contact your Codan representative.
Modem Info:
Connected|Disconnect|
Timeout|No Response
An RM50 HF Data Modem has been detected, disconnected, become
inactive due to no activity within a timeframe, or is not responding.
Table 53: System messages (cont.)
Message Description

Codan 2110 series Specifications

General

Brand	Codan
Model	2110 series
Category	Transceiver
Language	English