ANSI Hardware Installation Manual Fiber optic cable management in the
7360 ISAM FX-16 shelf
Issue: 09 3HH-12893-AAAA-TCZZA 149
DRAFT
Procedure 28 Installing an optical module
To install optical modules, proceed as follows:
1 Put on an antistatic wrist strap and connect it to a grounding point.
2 Install an optical module as follows:
i Align the optical module with an optical module port and slide it into the port until it clicks
into place.
ii Remove the rubber cap from the optical module.
3 STOP. This procedure is complete.
Caution — It is important to install optical modules prior to connecting
power to a 7360 ISAM FX shelf.
Note — The optical module can only be removed when the pull-down
bar is released.
To Next Page
Loading...
Need help?
General
