ANSI Hardware Installation Manual Connector pinning on NT card
Issue: 09 3HH-12893-AAAA-TCZZA 453
DRAFT
26 Connector pinning on NT card
26.1 Overview
26.2 1PPS-TTL interface signal
26.3 10 MHz-GPS interface signal
26.4 ToD/PPS interface signal
26.5 Local craft interface
26.1 Overview
This section describes the following connector signals and pinnings for the
7360 ISAM FX NT cards:
• 1PPS-TTL interface signal
• 10 MHz-GPS interface signal
• ToD/PPS interface signal
• Local craft interface
26.2 1PPS-TTL interface signal
Table 27 describes the signal from the 1PPS-TTL interface on the SMA connector.
Table 27 1PPS-TTL interface signal list
26.3 10 MHz-GPS interface signal
Table 28 describes the signal for the 10 MHz GPS interface on the SMA connector.
Signal name Type Description
1PPS-TTL Output 1PPS output, PTP slave mode
(single-ended, 50Ω)
Input 1PPS input, PTP master mode
(single-ended, 50Ω)
Shield Input Frame ground