ANSI Hardware Installation Manual Installing cards in the 7360 ISAM FX-8 shelf
Issue: 09 3HH-12893-AAAA-TCZZA 291
DRAFT
Figure 156 Label for earth bonding point
15.6.2.2 Cards with optical fiber connectors
Observe the following.
Figure 157 shows a laser classification label.
Danger — Risk of eye damage or skin burns by laser emission.
When installing optical cards or handling optical fibers, never
look inside connectors of cards or fibers when these are not
connected.
Put end caps on open connectors to protect against
unexpected emission.
Caution — Risk of damage by ESD when card is not
connected.
This card contains devices that are susceptible to damage
caused by ESD in unconnected circuit conditions.
Carefully follow ESD safety precautions.
To Next Page
Loading...
Need help?
General
