ANSI Hardware Installation Manual 7360 ISAM FX-4 shelf cabling
Issue: 09 3HH-12893-AAAA-TCZZA 345
DRAFT
Observe the following safety notes:
18.3.1 Grounding cable type
As shown in Figure 193, the 7360 ISAM FX-4 includes two grounding cable
connectors. Each ground lug is a 4 AWG, with 1/4 in. holes, with 3/4 in. spacing,
single crimp, peep, copper, UL and CSA recognized dual-hole lug. The preferred
cable is 4 AWG, green with a yellow stripe. Other types and sizes of wire and lugs
can also be used provided they meet the requirements of Article 250 of the NEC.
18.3.2 Cable routing and connection
The grounding cable must be used when the shelf is stand-alone and will not be used
if the shelf is assembled in a rack. The cable is routed through an opening in the right
side of the shelf to the grounding terminal.
The connections for the grounding cable are shown in Figure 193. The grounding
cable is connected to the shelf frame with hardware included with the shelf.
Danger 1 — Rack or frame must be suitably connected to the
office grounding network in accordance with Article 250 of the
national electrical code (NEC) to ensure UL and CSA
compliance. If outside the United States, ground per local
electrical codes and practices.
Danger 2 — Possible risk of personal injury or damage to
equipment due to inaccurate or faulty ground cabling.
Inaccurate grounding connection can cause electric shock or
equipment damage when the rack power is switched on.
To Next Page
Loading...
Need help?
General
