Overview
52
ANSI Hardware Installation Manual
3HH-12893-AAAA-TCZZA Issue: 09
DRAFT
2.5 Installation materials and tools
You need the following tools to install the 7360 ISAM FX system equipment. Other
tools may be required to perform special procedures as specified in the instructions.
• adjustable wrench, 12 in. (30.5 cm)
• anchor setting tool
• cable cutters
• camera
• carpenter claw hammer, 24 to 40 oz (0.68 to 1.13 kg)
• chalk line and chalk
• container for asbestos flooring drilling residue, if necessary
• crimping pliers
• diagonal cutters, 5 in. (12.7 cm)
• digital multimeter (volt-ohmmeter)
• extension cord, 50 ft (15 m)
• felt marking pens
• hex driver set with bits
• level, 3 ft (1 m)
• measuring tape
• needle-nose pliers
• open and box-end wrenches, 3/8 to 11/16 in. (9.5 to 17.5 mm)
• #2 Phillips and flathead screwdriver
• pinch bar
• rotary impact drill and associated drill bits
• safety glasses
• shears, common
• shims, 0.06 in., 0.09 in., and 0.12 in. (1.5 mm, 2.3 mm, and 3.1 mm)
• shop vacuum cleaner
• socket set, 3/8 in. drive with ratchet handle and extensions
• static protection accessories
• tin snips
• torque wrench
• wire stripper
Note — All tools used on working equipment must be insulated.
To Next Page
Loading...
