Nokia 7360 Intelligent Services Access Manager FX Series User Manual

ANSI Hardware Installation Manual Installing cards in the 7360 ISAM FX-4 shelf
Issue: 09 3HH-12893-AAAA-TCZZA 377
DRAFT
6 Wait until the NT card in the NT-A slot is fully operational. The card first displays a heartbeat
signal, that is, the green PWR LED is flashing. Then the card displays an enabling operation
signal, that is:
• the green PWR LED is steady on
• the green A/S LED is steady on
• the red ALM LED is off
7 Install the second NT card in slot NT-B in the same way, then install the NT dummy panels
in any unused, unpopulated NT card slot to maintain proper operation.
8 STOP. This procedure is complete.
Procedure 84 To install LT cards
Depending on the configuration, the 7360 ISAM FX-4 can house up to 4 line termination (LT)
cards.
Figure 218 shows the LT card slots.

Nokia 7360 Intelligent Services Access Manager FX Series Specifications

General

Brand	Nokia
Model	7360 Intelligent Services Access Manager FX Series
Category	Network Hardware
Language	English