Omron FQ2-S/CH Series

Reading with OCR
FQ2-S/CH User’s Manual
155
4
Setting Up Inspections
Parameter Setting Description
Matching mode
Direct Input (Default)
Calendar Matching
Code Matching
Select your attempted Matching mode.
Item ref.
The following registered func-
tion before setting of item ref.
Bar code
2D-code
2D-code (DPM)
(Default: None)
Use this parameter when you set the latest result as a verifica-
tion string.Specify the Processing item for the verification string.
Line for varif.range Check
Un-check (Default)
Select the line 1-4 for which to apply Calendar Matching.
L1. verif. range
1 to 1024
(Default
Start Line: 1
Finish Line: 1024)
Specify the result range of Calender Machining function that is
compare with line 1.
L2. verif. range Specify the result range of Calender Machining function that is
compare with line 2.
L3. verif. range Specify the result range of Calender Machining function that is
compare with line 3.
L4. verif. range Specify the result range of Calender Machining function that is
compare with line 4.