Omron FQ2-S/CH Series

External Reference Parameters
498
FQ2-S/CH User’s Manual
Edge Rotation Position Compensation
700 Display
settings
Position compensation
X display
Set / Get 0: ON, 1: OFF 0 --- ---
701 Position compensation
Y display
Set / Get 0: ON, 1: OFF 0 --- ---
702 Detected edge mid-
point position X display
Set / Get 0: ON, 1: OFF 0 --- ---
703 Detected edge mid-
point position Y display
Set / Get 0: ON, 1: OFF 0 --- ---
704 Detected edge position
X0 display
Set / Get 0: ON, 1: OFF 0 --- ---
705 Detected edge position
Y0 display
Set / Get 0: ON, 1: OFF 0 --- ---
706 Detected edge position
X1 display
Set / Get 0: ON, 1: OFF 0 --- ---
707 Detected edge position
Y1 display
Set / Get 0: ON, 1: OFF 0 --- ---
Exter-
nal ref-
erence
number
Category Data name Set / Get Data range Default Expres-
sion text
string
Logged data/
Judgement
parameter
0
Mea-
sure-
ment
result
Judgement Get only −2: No judgement (not measured)
0: Judgement is OK
−1: Judgement is NG
−13: Teaching not performed error
−14: Figure not registered error
−15: Out of range error
−2 JG Logged data
5 Position compensation TH Get only −99,999.9999 to 99,999.9999 0 DT Logged data
6 Detected edge position X0 Get only −99,999.9999 to 99,999.9999 0 X0 Logged data
7 Detected edge position Y0 Get only −99,999.9999 to 99,999.9999 0 Y0 Logged data
8 Detected edge position X1 Get only −99,999.9999 to 99,999.9999 0 X1 Logged data
9 Detected edge position Y1 Get only −99,999.9999 to 99,999.9999 0 Y1 Logged data
10 Detected edge angle Get only −180 to 180 0 TH Logged data
11 Standard position X0 Get only −99,999.9999 to 99,999.9999 0 SX0 Logged data
12 Standard position Y0 Get only −99,999.9999 to 99,999.9999 0 SY0 Logged data
13 Standard position X1 Get only −99,999.9999 to 99,999.9999 0 SX1 Logged data
14
Mea-
sure-
ment
result
Standard position Y1 Get only −99,999.9999 to 99,999.9999 0 SY1 Logged data
15 Standard edge angle Get only −180 to 180 0 STH Logged data
103 Output
parame-
ter
Reflect Set / Get 0: Yes, 1: No 0 --- ---
Exter-
nal ref-
erence
number
Category Data name Set / Get Data range Default Expres-
sion text
string
Logged data/
Judgement
parameter