Omron FQ2-S/CH Series

Convenient Functions for Operation
FQ2-S/CH User’s Manual
413
7
Convenient Functions
7-9 Convenient Functions for Operation
FQ2-S1
FQ2-S2
FQ2-S3 FQ2-S4
FQ2-CH
This section describes the functions that can be used during Sensor operation.
Setting a Password to Prevent Unwanted Changes
A password can be set to prevent unwanted changes to settings.
If a password is set, you cannot change from Run Mode to Setup Mode without entering the password.
Setting a Password
(Setup Mode) − [Sensor settings] − [Password settings]
1 Press [Password on/off] and press [ON].
2 Press [Enter password].
3 Enter a password containing up to 15 characters and press [OK].
Clearing the Password
(Setup Mode) − [Sensor settings] − [Password settings]
Press [Password on/off] and press [OFF].