Starting Operation
FQ2-S/CH User’s Manual
353
6
Operation
Moving to Run Mode
You can move from Setup Mode to Run Mode by using the following procedure.
1 Press [Run].
2 Press [Switch to Run mode.].
3 Press [Yes].
If you press [No], the setting will not be saved
and you will move to Run Mode.
• Returning to Setup Mode
Press and press [Sensor settings].
• Signal Status When Moving to Run Mode
When moving to Run Mode, the signal will change as shown below and data can be input from and output to an
external device.
Note
ON
OFF
The BUSY signal that was
always ON will turn OFF.
BUSY signal
Display
Run Mode
Setup Mode
To Next Page
Loading...
