Omron FQ2-S/CH Series

Reading 2D-codes
198
FQ2-S/CH User’s Manual
Changing the Character String That Is Output for Read Errors
You can change the character string that is output for read errors.
[Inspect] − [Inspection] − [Add item.] − [2D-code] − [Details] Tab Page − [Output parameter] −
[Error string]
The read character string is output after the other output data (data 0 to 31 in the output data settings) after the mea-
surement, such as the inspection item parameters and calculation results. Refer to the following section for the loca-
tion of the output area for the character string and other details.
Vision Sensor FQ2-S/CH Series User's Manual for Communications Settings (Cat. No. Z338)
Section 1 Overview of Communication Specifications
Setup Item Setting Value Description
Error string Max. 20 digits
(Default value: NG)
Sets the text string to be output when a read error occurs.
ASCII code table: p. 196
Note