Saving Data to the Sensor
350
FQ2-S/CH User’s Manual
5-5 Saving Data to the Sensor
FQ2-S3 FQ2-S4
Until you have saved your settings explicitly to the memory in the FQ2 Sensor, the settings are only stored
temporarily. They will be lost if the power is turned OFF. Execute [Save data] after you have finished making
your settings.
The FQ2 Sensor will remind you to do so with a message if you switch from Setup Mode to Run Mode. You can
use this feature to keep the previous settings and discard the new settings if desired, but keep in mind that all
settings that are not saved explicitly are replaced by the settings that are stored in the memory of the FQ2
Sensor the next time you turn ON the FQ2 Sensor.
Do not turn the power supply OFF while data is being saved. The data that is being saved may become
corrupted.
[Test]
1 Press [Save data].
2 Press [Yes].
• The data that are saved by this operation are scene data, system data, calibration data, touch finder data, and dic-
tionary data*
1
.
*1: Only supported on the FQ2-S4/CH Series.
Scene data and system data details: p. 407
• Measurement data and image data cannot be saved in this way.
Logging measurement data: p. 392
• Settings data can also be backed up to an external memory.
Saving settings: p. 406
Note
To Next Page
Loading...
Need help?
General
