Inspecting with the Shape Search II Inspection Item
FQ2-S/CH User’s Manual
255
4
Setting Up Inspections
Increasing Processing Speed
The following two methods can be used to reduce processing time.
• Reduce the range in which a shape search II is performed for the model.
Changing the Model Regions: p. 227
• Reduce the angle range setting.
Adjust the [Angle range] parameter to reduce the range in which a shape search II for the model is performed.
Select the Results to Output: p. 237
• Raise [Candidate level].
Raise [Candidate level], then processing time will be shortened.
Select the Results to Output: p. 221
To Next Page
Loading...
