Inspecting with the Sensitive Search Inspection Item
FQ2-S/CH User’s Manual
267
4
Setting Up Inspections
Increasing Processing Speed
The following two methods can be used to reduce processing time.
• Reduce the range in which a search is performed for the model.
Changing the measurement region: p. 227
• Reduce the angle range setting.
Adjust the [Angle range] parameter to reduce the range in which a search for the model is performed.
Setting the angle range: p. 266
For more accurate detection, consider the followings:
• Set [Model mode] to [Stable]
•
Raise [Candidate level].
For [Candidate level], refer to Select the Results to Output: p. 221
To Next Page
Loading...
