Setting Up Ethernet
68
FQ2-S/CH User’s Manual
● Using a DHCP Server
・ Sensor
(Setup Mode) − [Sensor settings] − [Network] − [Ethernet] − [IP address setting]
1 Press [DHCP].
・ TouchFinder
(Setup Mode) − [TF settings] − [Ethernet] − [AUTO]
1 Press [ON].
Connecting to Sensors from External Devices Such as PLCs
Set the IP address of the Sensor according to the network where the external devices, such as PLCs, are
connected.
(Setup Mode) − [Sensor settings] − [Network] − [Ethernet] − [IP address setting]
1 Press [Fixed].
2 Set the IP address and subnet mask according to the network where the external devices, such
as PLCs, are connected.
If you connect OMRON CS/CJ-series PLCs to the Ethernet, the following Default IP addresses are assigned to the
PLCs.
• IP address: 192.168.250.node_address
To Next Page
Loading...
