Installation
FQ2-S/CH User’s Manual
47
2
Installation and Connections
Mounting to DIN Track
Installation Procedure
• Attach End Plates (sold separately) on the sides of the Touch Finder on the DIN Track.
• If other devices will be installed next to the Touch Finder on the same DIN Track, make sure that sufficient space is
kept between the devices as indicated on previous page.
• Always hook the clip at the top of the Touch Finder on the DIN Track first. If the lower clip is hooked on first, the
Touch Finder will not be mounted very securely.
Removal Procedure
1 Press the slider on the Touch Finder to the top.
2 Hook the clip at the top of the Touch Finder on
to the DIN Track.
3 Press the Touch Finder onto the DIN Track until
the bottom clip clicks into place.
1 Pull down on the slider on the Touch Finder.
2 Lift the Touch Finder at the bottom and remove
it from the DIN Track.
1
2
3
3
To Next Page
Loading...
