SD Card Operations
FQ2-S/CH User’s Manual
411
7
Convenient Functions
Removing an SD Card from the Touch Finder
Never remove the SD card while data is being saved or read. The data on the SD card may be corrupted.
Do not restart or turn OFF the power supply to the Sensor or Touch Finder while a message is being displayed
saying that data is being saved to or read from the SD card. The settings or system data may be corrupted.
Checking the Available Space on the SD Card
Before saving data to the SD card, use the following display to make sure that there is sufficient space
available on the SD card.
(Setup Mode or Run Mode) − [TF settings] − [SD card] − [SD card information]
1 Open the cover to the SD card slot on the top of the Touch Finder.
2
Press in on the SD card until you hear a click.
3
Pull out the SD card.
4
Close the cover to the SD card slot.
1 The following information in the SD card insert-
ed in the Touch Finder can be checked.
To Next Page
Loading...
