Reading 2D Codes (DPM)
204
FQ2-S/CH User’s Manual
7
Press [Yes] to register the read result in the master
data.
The master data contains the character strings from
the 2D codes that are registered to verify whether
the read character strings match specific character
strings.
8
Press the master data in which the read characters will be registered.
9
Press [Back] to end teaching.
You can use the menu commands that are displayed for at the right of the display to adjust the settings that
resulted from teaching.
• [Insp. region]: You can change the measurement region.
• [Camera setup]: You can adjust the Camera focus, brightness, and other factors to input a better image.
Adjusting Image Quality: p. 76
• [Meas. Parameter]: You can change the type of code to read, the read settings, etc.
Detailed Parameters: p. 196
• [Continuous test]: You can start test measurements of displayed images for the settings that were taught.
Performing Test Measurements: p. 340
Note
To Next Page
Loading...
