Reading 2D Codes (DPM)
FQ2-S/CH User’s Manual
211
4
Setting Up Inspections
• Measurement parameters other than [Grid correction], [Fast mode] and DPM print quality are initialized as set when
[Teach] is pressed.
• When the "Code type" setting is changed, some settings are initialized as shown below.
Cell
(DataMatrix only)
Shape: Square
10 × 10, 12 × 12,
14 × 14, 16 × 16,
18 × 18, 20 × 20,
22 × 22, 24 × 24,
26 × 26, 32 × 32,
36 × 36, 40 × 40,
44 × 44, 48 × 48,
52 × 52, 64 × 64, Auto
(Default)
Shape: Rectangle
8 × 18, 8 × 32, 12 × 26,
12 × 36, 16 × 36, 16 × 48,
Auto (Default)
Sets the number of code cells.
DPM print quality
(Data Matrix only)
ON
OFF (Default)
Sets print quality ON/OFF.
Timeout
1 to 9999 ms
(Default value: 9999)
Sets the timeout time in read processing.
A read error occurs if measurement does not end after the preset time-
out time is exceeded.
Parameter Initialized due to "Code type" change
Code type Initialized
Auto length
Size Initialized
Reverse
Code color
Grid correction
Fast mode
Shape Initialized
QR Code Model Initialized
Error Correction Level Initialized
Cell Initialized
DPM print quality
Parameter Setting Description
To Next Page
Loading...
