Calibration
372
FQ2-S/CH User’s Manual
4
Press [No. 1] and then press [Modify].
5
Press the Camera coordinates to register on the
display to select them.
A cross mark will be displayed on the selected po-
sition.
• You can enlarge the display.
Image Zoom: p. 380
• You can fine-tune the coordinates that are set.
Press
[] − [Console] on the right of the display to display the console.
Press the Cross Key on the console to change the coordinates one pixel at a time.
6
Press [OK].
7
Enter the actual coordinates of the specified po-
sition.
Press [] − [Actual coord.] on the right of the dis-
play.
Note
To Next Page
Loading...
