Omron FQ2-S/CH Series

Calibration
374
FQ2-S/CH User’s Manual
Reference
With this method, the calibration settings are based on measurement results.
When you enter the actual coordinates of the position that results from searching for a registered model, the
calibration parameters are calculated automatically.
(The position resulting from the search is found at the subpixel level.)
(Setup Mode) − [Calibration]
1 Select the data region to set from [Calibration
data 0] to [Calibration data 31].
2 Press [Modify].
3 Press [] − [Reference] on the right of the dis-
play.
4 Press [No. 1] and then press [Modify].
Measure three positions and enter the actual coordinates of them.
Model