Convenient Functions for Setup
FQ2-S/CH User’s Manual
421
7
Convenient Functions
• Saving Images in the Sensor to an SD Card
The images that are temporarily saved inside the Sensor can be saved to an SD card.
(Setup Mode) − [Save to file] − [Logging] Tab Page
1 Press [Logging image].
2
Select whether to save the most recently logged image or to save all of the data that is logged in
the Sensor.
* Measurement ID is a value equal to the measurement count minus 1. When launching the FQ2, the count starts from zero.
• Saving Images in an SD Card
The image data can be saved in the SD card each time measurements are performed.
(Run Mode) − [Logging]
Logging All Data (File Logging): p. 394
You can also save the data in Setup Mode by using (Display Arrangement)
− (Log Image Button).
Displaying Image Data
• Images Saved in Internal Sensor Memory
(Setup Mode) − − [Log]
• Image Files in a SD Card
(Setup Mode) − − [Logging image file] or [Camera image file]
Display Functions - Displaying a Saved Image: p. 382
Storage location File name
\sensor_name\LOGIMAGE
Img_Scn0**_YYYY_MM_DD-HH_MM_SS(n)_MeasurementID_OverallJudge-
mentResult.IFZ*
Example: The following name would be used for files saved at 10:10:21 pm on March
10, 2010.
Img_Scn000_2010_03_10-22_10_21(0)_0000_OK.IFZ
To Next Page
Loading...
