Connecting a Previous Touch Finder (FQ-D30/D31) to the FQ2-S Sensor
FQ2-S/CH User’s Manual
577
Appendices
9
8 Select the Browse Button (...) and select the file that was saved in step 6, above.
9 Set the Sensor Find Method parameter to [Local Auto].
When a sensor cannot be detected automatically, or when connecting across routers, use the [File List]
function. Sensors, whose IP addresses are listed in the file, can be detected with this function.
10 If there is more than one network card (NIC) installed in the PC, select the NIC that is connected
to the Sensor.
More than one NIC will be displayed for a PC with a wireless LAN.
To Next Page
Loading...
