© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
2 Inspect jumper cable connecting fitness equipment to the video drop.
If it is visibly damaged or disconnected, replace or reconnect. If
it passes visual inspection, swap with a known good jumper cable.
If a TV channel now appears, the cable is the cause. Replace the
jumper cable. If the channel does not appear, perform the same
check on the F connectors.
3 Inspect the cable that runs from the patch panel at the bottom of
the machine to the console. If this is disconnected or damaged,
reconnect or replace. If the cable passes visual inspection, use a
known good cable to bypass this cable. If the TV channel appears,
replace the coax cable running through the machine.
4 Connect the machine to a known good A/V drop. If the TV channel now
appears on the console, verify the drop is good. If not, have the
customer contact their A/V service technician to repair the drop.
5 Verify signal strength with signal meter.
6 As above, verify condition and connections of coax cables as well as
verify quality of signal to that drop. Verify signal strength with
signal meter.
7 Enter the Settings Menu. Select System Settings, then TV Settings.
Verify that unit is set for United States. See P80 TV Settings (on page
81).
Poor Quality Video - All Units
Description
Television signal is present, but picture quality is consistently or
inconsistently poor across all available channels.
Possible Causes
1 Loose or damaged coaxial cable at or near head end.
2 Poor television signal from head end.
3 Poor television signal to club.
4 All machines were configured using incorrect region setting.
To Next Page
Loading...
Need help?
General
