© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
28 To ease the installation of the flat belt to the flat belt terminal
clamp, have an assistant hold the stairarm up or block up the
stairarm so that the flat belt will have a sufficient amount of
slack.
29 Loop the end of the flat belt to the 10 inch mark. While holding the
flat belt end on the 10 inch mark, work the loop into the terminal
belt clamp. A 1/2 inch deep set socket can be used to assist in
pushing the belt into place. When the flat belt loop is about half
way into the terminal clamp, push the pin into the flat belt loop.
30 Continue to work the flat belt loop and pin into the terminal clamp
until the side of the flat belt is resting next to the clamp screw.
Ensure the pin is centered within the terminal clamp.
Figure 148: Flat Belt Terminal Pin
31 Install the second 1/4-20X1 replacement screw and shim that secure
the flat belt to the terminal clamp. Do not fully tighten at this
time.
Outside Flat Belt Alignment
32 The flat belts ends will now need to be adjusted to their final
position before the flat belt clamp screws can be fully tightened.
Gently press down on the stairarm pedal that corresponds to the
replacement belt.
33 Gradually increase downward pressure on the stairarm pedal while
closely monitoring the flat belt ends for movement through the belt
clamps.
To Next Page
Loading...
Need help?
General
