Precor AMT Series User Manual

© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Page 299
Figure 239: Crank Arm Bolt Removal/ Installation
11 Remove the screw and square washer that secures the drive input
pulley assembly to the drive input housing. Pull the drive input
pulley out of the housing.
Note: If necessary a rubber mallet can be used to dislodge the input pulley
assembly from the housing by tapping on the input shaft from the crank arm
side.

Precor AMT Series Specifications

General

Brand	Precor
Model	AMT Series
Category	Elliptical Trainer
Language	English