© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
17 Touch OK to return the Settings menus.
18 Exit the service mode as described in steps 14.
19 Repeat the described process steps 11 though 16 for any remaining
P80 consoles.
Replacing the P80 Console
Required Tools
♦
2- 7/16 in open end wrenches
♦
¹/₄-inch hex wrench
♦
SAE ⁵/₃₂-inch hex wrench
♦
SAE¹/₂-inch box-end wrench
♦
#2 Phillips screwdriver
♦
Wire cutter
Console Mounting - Removal
1 Remove the rear vent cover. Do not use a sharp tool, such as a flat
bladed screwdriver, to pry up the cover, as you can damage the
covers and possibly components inside the console. When the cover
starts to come loose, gently unsnap it from the P80 and set it aside
where it will not be scratched.
To Next Page
Loading...
