Precor AMT Series User Manual

© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Page 275
Figure 213: Dive Input Belt
12 The belt gauge should read approximately 135 ±5 lbs. If the Drive
belt tension is significantly high or low the belt tension may be
adjusted by following the steps below. See Drive Belt Gauge Instructions
(on page 142)
13 Loosen or tighten the step up pulley adjustment bolt until the belt
gauge reads approximately 140 lbs. See Drive Belt Gauge Instructions (on
page 142)

Precor AMT Series Specifications

General

Brand	Precor
Model	AMT Series
Category	Elliptical Trainer
Language	English