© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Figure 59: Gas Shock
5 Release the tension from both of the inside flat belts by lifting up
the stairarms and pull the flat belts off the flat belt pulleys and
gently set the stairarms down.
6 Remove the hitch pin from the incline motor mounting pin.
7 Remove the incline motor mounting pin, if the incline is jammed or
has excessive pressure on the pin, it may be necessary to drive the
pin out of the incline motor tube and incline platform using a punch
and rubber mallet.
To Next Page
Loading...
