© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Figure 174: Main Shaft Clamp Bolts
Caution: It is recommended to have assistance available for the
following step(s).
Time Saver Tip: When installing the
replacement flat belt, tape the end of the replacement belt to the old flat belt at
the cam side and then pull the new belt through the upper arm as the old belt
is removed.
If the belt has already been removed, you can use a fish tape or coat
hanger to pull the belt through the upper arm. Ensure the flat belt is
routed over the top of any hardware that may be crossing the inside of
the upper arm.
17 With assistance, lift the front arm and flat belts out of the lower
main shaft clamp and upper arm.
18 Remove the other front arm and flat belts.
To Next Page
Loading...
Need help?
General
