© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Note: Ensure the Incline tube and Incline screw do not turn after the Incline
tube is free from the Incline platform. Turning the Incline tube or screw will
cause the Incline motor to become out of calibration.
Figure 325: Incline Motor Hitch Pin and Mounting Pin
Gas Shock Installation
8 Secure the bottom of the replacement gas shock to lower mounting
stud with retaining clip removed in step 5.
9 Adjust the height of the gas shock by lower or raising the front of
the Incline platform until the gas shock and the upper mounting stud
align.
10 Press the gas shock onto the mounting stud and secure the gas shock
to the upper mounting stud by pushing in on the tension clip.
Caution: It is recommended to have assistance available for the
following step(s).
To Next Page
Loading...
Need help?
General
