© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Figure 205: Upper Outside Cam Pin
16 Install the second 1/4-20X1 replacement screw and shim that secures
the flat belt to the cam. Do not tighten fully at this time.
Stairarm Installation
17 Position the stairarm in the front arm.
18 Place the shaft of a Philips screw driver into the drain hole on the
bottom of the front arm and thread one of the two 1/2-13X1 screws
into stairarm. Using the installed screw, rotate the front arm
bearing until the screw driver engages into the bearing, locking the
bearing. You may have to rotate the bearing one full turn to align
the bearing lock hole with drain hole.
19 Once the screwdriver has locked the bearing preventing further
rotation, fully tighten the inside and outside mounting bolts,
torque to 83 foot pounds or 1000 inch pounds.
20 Remove the screwdriver from the drain hole.
To Next Page
Loading...
Need help?
General
