© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Figure 186: Flat Belt Terminal Adjustment
46 Fully tighten the stop bolt, torque to 300 inch pounds (25 ft-lbs)
or 25 foot pounds.
47 Replace the flat belt guard.
48 Replace the cam covers.
49 Replace the body covers.
50 Replace the vertical handle bars.
51 At the console enter the access code PAUSE,5,1,7,6,5,7,6,1, to enter
into the diagnostics software. Navigate to the STRIDE COUNT RESET
section and reset the flat belt stride count.
52 Fully check the operation of the AMT.
53
Replacing a Front Arm Assembly - Without Flat Belts and
Non-Press Fit Cams. (Prior to 4/3/2013)
Caution: Replace only one front arm at a time. The cams of the two
front arms are in opposing positions from one another, replacing one
front arm at time will prevent the cams from being incorrectly
positioned.
To Next Page
Loading...
Need help?
General
