© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
•
Friendly Name
•
Site Code – This is given at the time of the dispatch.
•
Base Serial – The base serial number is located on the exercise
equipment.
19 Friendly Name - It is recommended that you have a list of the
equipment with friendly names already assigned, such as Elliptical
1, Treadmill 22, and so forth. Touch NEXT.
20 Enter the Site Code using the on-screen keypad, then touch NEXT.
21 Enter the Base Serial Number using the on-screen keypad, then touch
NEXT.
22 Enter the Friendly Name using the on-screen keypad, then touch NEXT.
23 The next screen displayed will be the Registration Summary screen.
Review the screen to ensure the information entered is correct
before completing the registration. If the information is not
correct touch  BACK until the screen with incorrect information is
displayed. Make the corrections and then touch NEXT unit you are
back at the Registration Summary Screen.
24 Touch Register to submit the data.
25 If the registration was successful a screen with current software
version will be displayed. Touch FINISH to the Systems Settings
menu, if a newer software version is available, the console will
automatically start the download.
26 Touch  BACK to Settings.
P80 Display
The display settings allow you to configure Measurement units, Standby
Mode Delay, Time Zone, and Closed Captioning.
1 Refer to Procedure, P80 Settings (on page 51) to access the Display
menus.
2 To select a Display Settings touch on an item in the Display menu,
see .
3 Touch  BACK to Settings, P80 Display Settings Table (on page 80).
To Next Page
Loading...
Need help?
General
