© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Section Seven
Checking the AMT Operation
In This Section
Checking AMT Operation............................. 125
Checking AMT Operation
This section provides you with a quick method of checking AMT
operation. Check the operation of the AMT at the end of most
maintenance procedures.
Procedure
1 Start striding on the AMT or plug the optional external power supply
(when available) into the AMT and the AC outlet.
2 When the PRECOR banner displayed, press QUICK START.
3 Select Resistance Level 1 and press ENTER.
4 Operate the AMT for 4–5 minutes. As you operate the AMT, concentrate
on the operating sounds made by the unit. Be on the alert for
unusual rubbing, hitting, grinding, or squeaking noises.
5 Ensure that the AMT is properly leveled, that the two "feet" are in
contact with the floor and there is no side to side rocking.
6 If the AMT makes unusual noises or the electronic display does not
change appropriately, troubleshoot per Section, AMT Base
Troubleshooting Procedures (on page 147).
7 Press the RESISTANCE  key until you reach Resistance Level 10.
Operate the AMT for another 2–3 minutes.
8 If the AMT resistance does not change or the operation of the AMT
feels inconsistent compared with Resistance Level 1, troubleshoot
per Section, AMT Base Troubleshooting Procedures (on page 147) .
9 Press the RESISTANCE  key until you reach Resistance Level 20.
Operate the AMT for another 2–3 minutes.
To Next Page
Loading...
Need help?
General
