© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Figure 128: Upper Inside Cam Pin Install
16 Install the second 1/4-20X1 screw and shim, but do not fully tighten
at this time.
Inside Flat Belt Routing
17 Route the flat belt over the top of the cam towards the back of the
AMT and down, over the first flat belt pulley, then under the second
flat belt pulley to the front belt clamp. If the flat belts are not
long enough to route through the pulley's, skip the belt routing
until the belt flat belt installation is completed
To Next Page
Loading...
