© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Section Eight
Inspection and Adjustment
Procedures
In This Section
Measuring the Resistance of a Generator............ 127
Inspecting and Adjusting the H-brake Belt Tension.. 129
Inspecting and Adjusting the Generator Belt Tension 130
Inspecting and Adjusting the Drive Input Belt Tension 132
Calibrating the Incline Motor...................... 137
Drive Belt Gauge Instructions...................... 142
Measuring the Resistance of a Generator
Caution: If an external power supply is connected to the AMT,
disconnect the external power supply from the AMT before continuing
with this procedure.
Procedure
1 Remove the right side cover as per Procedure, Cover Replacement (on
page 152).
2 Remove the positive battery wire from the lower PCA.
To Next Page
Loading...
