SC No. Type Error Name/Error Condition/Major Cause/Solution
Remove the jammed paper or slip of paper from the tray, and check if the
SC occurs by turning the main power OFF then ON. If the SC occurs
again, do the following steps. Check if the SC reoccurs by cycling the
power after each step.
1. Check if all connectors in Tray 3 are connected securely. Reconnect
the connectors if they are disconnected, or loose.
2. Check the harness in Tray 3. Replace the harnesses if it is
disconnected, or damaged.
3. Check if the motor runs, sensors turn OFF/ON, has no overloads,
and is properly driven. Replace the parts if there are any defects.
4. Check if there are any signs of a short circuit. Replace the parts if
there are any defects.
SC503-34 B 3rd Tray Paper Position Error (LCIT PB3170/PB3230 (D695))
During left/right tray set, or when power is switched ON, or when
transfer is complete, "open" is detected 3 times consecutively by end
fence open/close detection.
(Up to 2 times consecutively, LCIT transmits "tray set incorrectly" to the
main machine.)
• Paper set incorrectly (paper is offset from position for pushing end
fence)
• Foreign object entry (foreign object is caught in the position for
pushing end fence)
• End fence open/close sensor error/connector missing
• Harness broken
• Bank control board defective
Service Call 501-584
903
To Next Page
Loading...
