SC No. Type Error Name/Error Condition/Major Cause/Solution
Remove the jammed paper or slip of paper from the tray, and check if the
SC occurs by turning the main power OFF then ON. If the SC occurs
again, do the following steps. Check if the SC reoccurs by cycling the
power after each step.
1. Check if all connectors in Tray 3 are connected securely. Reconnect
the connectors if they are disconnected, or loose.
2. Check the harness in Tray 3. Replace the harnesses if it is
disconnected, or damaged.
3. Check if the motor runs, sensors turn OFF/ON, has no overloads,
and is properly driven. Replace the parts if there are any defects.
4. Check if there are any signs of a short circuit. Replace the parts if
there are any defects.
SC503-35 B 3rd Tray Transfer Error (LCIT PB3170/PB3230 (D695))
• Transfer end detection error
At right tray paper end (right tray lower limit detection, left tray
paper detection), left tray paper is transferred to the right tray, but
the left tray paper sensor is detected although a predetermined time
elapsed (paper missing is not detected), for 3 times consecutively.
(Up to 2 times consecutively, LCIT transmits "tray set incorrectly" to
the main machine.)
• Transfer motor error/connector missing
• Left tray paper sensor error/connector missing
• Harness broken
• Bank control board defective
• Paper overload
• Foreign object, such as paper scrap, is caught between the left tray
and the tray transfer motor
• Paper set incorrectly
• Timing belt damage/dropout
• Timing pulley damage/dropout
• Transfer fence defective
• Foreign object, such as paper scrap, is caught inside the left tray
6. Troubleshooting
904
To Next Page
Loading...
