Acquisition and waveform setupMXO 4 Series
131User Manual 1335.5337.02 ─ 07
PROBe<ch>:PMETer:RESults:DIFFerential? on page 529
PROBe<ch>:PMETer:RESults:NEGative? on page 529
PROBe<ch>:PMETer:RESults:POSitive? on page 530
6.4.3.2 Setup for R&S RT-ZD differential probes
Figure 6-4: Probe setup for active differential probe R&S
RT-ZD30
Most settings are common settings, which are available for all probe types. See Chap-
ter 6.4.1, "Common probe settings", on page 125 for description of these settings.
R&S RT-ZD differential probes have the Rohde & Schwarz probe interface and support
its functions. For details, see Chapter 6.4.3.1, "Settings for the Rohde & Schwarz
probe interface", on page 130.
The "Offset" is the differential offset, see "Offset" on page 121.
Specific settings for R&S RT-ZD probes are the following:
Probes
To Next Page
Loading...
