Waveform analysisMXO 4 Series
205User Manual 1335.5337.02 ─ 07
In the "Rescale" tab you can adjust the vertical and horizontal scaling of the reference
waveform.
Vertical
Stretching and offset change the display of the waveform independent of the vertical
scale and position.
Enable ← Vertical
If enabled, the vertical offset and factor are applied to the reference waveform.
Remote command:
REFCurve<rc>:RESCale:VERTical:STATe on page 596
Scale factor ← Vertical
Sets the vertical scale factor. A factor greater than 1 stretches the waveform vertically,
a factor lower than 1 compresses the curve.
Remote command:
REFCurve<rc>:RESCale:VERTical:FACTor on page 595
Vertical offset ← Vertical
The vertical offset moves the reference waveform vertically. Enter a value with the unit
of the waveform.
Reference waveforms
To Next Page
Loading...
