ApplicationsMXO 4 Series
281User Manual 1335.5337.02 ─ 07
a) Connect the positive (+) signal socket of the differential voltage probe to the
line of the AC input.
b) Connect the negative (-) signal socket of the differential voltage probe to the
neutral of the AC input.
c) Connect the current probe to the line of the AC input.
5. Select the correct channels for the "Voltage" and the "Current" probes.
6. Select the "Standard".
7. Select the "Fund. Freq" according to your signal.
On the screen, you can see the measurement of the current, the voltage and the
power. Also there is a table giving information about important measurement
parameters. For details, see "Power harmonic results" on page 283.
Power harmonic settings
In this tab, you configure the current harmonic measurement parameters and display
settings.
Power analysis (option R&S MXO4-K31)
To Next Page
Loading...
